decomposition temperature是什么意思，decomposition temperature的意思翻译、用法、同义词、例句

分解温度

In order to reclamate more sulphate, the baking temperature should be near or just over the decomposition temperature of the sulphate.

为了提高硫酸盐的实收率，焙烧温度应接近或略超过硫酸盐的分解温度。

Analyzed by. DSC, the title resin modified by organopolysiloxna has high decomposition temperature which can be up to 239.3℃.

用有机聚硅醚对环氧树脂进行了化学改性，所得树脂经DSC分析，结果表明热分解温度高达239.3℃。

With the development of industry, higher demands for phenolic resin have been proposed, such as higher decomposition temperature, good wear resistance, sufficient toughness and strength, etc.

随着工业的发展，对酚醛树脂的使用提出了更高的要求，如较高的分解温度，较好的耐磨性能，足够的韧性和强度等。

TG-DTA test indicated the influence of the composite particles to the decomposition temperature of AP.

通过热分析测试所得功能复合粒子对AP分解温度的影响；

Used DSC and TG to research the thermal property of the KGM before and after regeneration, and found that both the decomposition temperature and the thermal stability had a little decline.

对再生前后魔芋多糖进行DSC和TG分析可知，再生后魔芋多糖的热分解温度和热稳定性均有所下降。

Influence of the consistence and decomposition temperature of carbonyl iron on particle size was studied. The select of the surface active agent and carrier was also discussed.

研究了羰基铁蒸气的浓度、热分解温度等条件对纳米级颗粒形成的影响，同时对界面活性剂、载液的选择也进行了探讨。

The temperature in the core of massive shrinkage compensating concrete is possibly higher than the decomposition temperature of ettringite due to the exothermic hydration of binder.

在大体积补偿收缩混凝土内部，由于胶凝材料水化放热，其最高温度可能超过钙矾石的分解温度，使水化初期生成的钙矾石分解；

PI-F film has good thermal stability with the initial decomposition temperature of 474 ℃.

薄膜具有优良的耐热稳定性，氮气中的起始热分解温度为474℃。

The influence of decomposition temperature on the threshold voltage is consistent with the principle of material design of thermochemical hole burning.

理论分析表明，阈值电压对热分解温度的依赖关系反映了活化能对热化学烧孔反应速度的影响。

The results of differential scanning calorimetry (DSC) showed that the decomposition temperature of ACPA decreased when it was chelated onto the particles.

差热扫描量热分析表明偶氮引发剂与纳米碳酸钙螯合后分解温度略有降低；

Higher decomposition temperature shows that FOX-7 has better thermal stability.

较高的分解温度表明FOX-7有较好的热稳定性。

DSC data showed that thermo-decomposition temperature of the copolymer remained unchanged at about 213℃, in spite of a great change in the number of sulfonate unit.

DSC数据显示，尽管树脂中磺酸基团的数量变化很大，但树脂的热分解顶点温度并没有明显的变化，保持在213℃左右。

Meanwhile,the Iow thermal-decomposition temperature makes theglass fabrication and the fibre drawing very difficult.

同时较低的玻璃热分解温度也给玻璃制备与拉丝工艺造成一定的困难。

In this paper, experimental study is made on decomposition temperature, decomposition ratio of calcined anhydrite, activity of decomposition products and stimulating effect on fly ash.

对高温煅烧硬石膏的分解温度与分解率，分解产物的活性与对粉煤灰的激发效应进行了试验研究，提出了初期和后期两期激发机理。

The TG curves show that the initial decomposition temperature of the system is 364℃.

热失重曲线表明，体系的起始分解温度为364℃。

One way to resolve ignition and combustion difficulties for AN-based propellant is to lower AN decomposition temperature, and to accelerate the thermal decomposition of AN.

降低硝酸铵的热分解温度，促进AN的热分解是解决硝酸铵推进剂点火和燃烧困难的途径之一。

It is deduced from the bonding parameter topological index He that a quantitative relationship must be existed between He and the thermal decomposition temperature of some sulfates.

从键参数拓扑指数一般形式出发，导出计算硫酸盐键参数拓扑指数公式，用于关联硫酸盐热分解温度的计算，结果满。

The results of DSC showed that decomposition temperature of regenerated fibers was similar to native fibers.

DSC研究结果表明再生柞蚕丝素纤维的热分解温度和天然柞蚕丝素纤维的热分解温度相似；

Zinc oxide was used as foaming auxiliary agent for the foaming system, which could lower the decomposition temperature and blowing gas of the foaming agent, met the requirement of product.

选择氧化锌作该体系发泡助剂，降低发泡剂分解温度、发气量，满足产品要求。

The composity, solubility, IR spectra, autoignition temperature and decomposition temperature of urushiol lanthanum chelate were determined.

制备出漆酚镧螯合物，测定了其组分、溶解性、红外光谱、自燃点、分解温度等性质。

The decomposition temperature and heat of cefazolin sodium pentahydrate were measured by the differential scanning calorimetry technique.

采用差热分析法测定头孢唑林钠的分解温度和分解热；

The laminate shows a combination of superior glass transition temperature, decomposition temperature, time to delamination at 288 DEG C, adhesion to copper foil, and excellent flame retardancy.

所述层压材料显示出优异的玻 璃化转变温度、分解温度、在288℃下的分层时间、对铜箔的粘合和极 好的阻燃性的组合。

The initial thermal decomposition temperature is 270 ℃, and the final temperature is 500 ℃.

热分解起始温度为270℃；热分解最终温度为500℃。

The crystallization and decomposition temperature of the ADP particles prepared by either direct freezing or spray freezing were reduced to some extent, while anti-solvent changed a little.

无论是直接冷冻还是喷雾冷冻法所制备的ADP颗粒，其晶化程度及分解温度均有一定程度的降低，而反溶剂法所得到的颗粒变化不明显。